SKF bearings|FAG bearings|INA bearings|TIMKEN bearings|NSK bearings - Eric bearing supplier

It is a part of SKF bearing, and its damage state usually includes deformation, breakage, abrasion, end face deformation, recessed surface/guide surface wear, etc. In order to avoid cage damage, the installation method, load, rotation and temperature conditions should be carefully checked, vibration should also be reduced, and t...

1. Tolerance selection and control of shaft and SKF bearing room After the SKF bearing is pressed into the bearing, it should rotate flexibly without a sense of blocking. If there is obvious inflexible rotation, it indicates that the size of the shaft is too large and the tolerance needs to be lowered. If the imported bearing is...

Maintaining IKO imported bearings is a prerequisite for bearing operation. Common maintenance is for bearing lubrication. After reading how to choose bearing lubrication methods, and understanding the bearing lubrication methods, you have a good understanding of bearing system maintenance. If necessary, let us see how to carry o...

1. Tolerance selection and control of shaft and INA bearing room INA bearing should rotate flexibly without blocking feeling after being pressed into INA bearing. If there is obvious inflexible rotation, it indicates that the size of the shaft is too large and the tolerance needs to be lowered. If the INA imported bearing is pre...

1. The impact of vibration on SKF bearings. In normal use, vibration is very sensitive to bearing damage, peeling, indentation, rust, cracks, wear, etc. will be reflected in the bearing vibration measurement. Therefore, by using a special bearing vibration measuring device (frequency analyzer, etc.), the magnitude of the vibrati...

The glass fiber reinforced nylon 66 cage used in INA bearings is suitable for a steady-state operating temperature of 120 degrees. The bearings are lubricated with oil. If the oil contains additives, it may shorten the life in the cage. If the temperature exceeds 120 degrees, CNPC will shorten the aging life of the cage. And sho...

For the use of bearings, noise is very common. Even low-noise bearings in FAG bearings have the same situation. So, why does noise occur? Today I will introduce its essence to you. (1) The raceway sound of FAG bearing and its control method The raceway sound is a slippery and continuous sound produced by rolling elements on the ...

1. Install precision Japanese NSK bearings correctly For the installation of precision NSK bearing products, some things should be paid attention to after installation. If it is not installed properly, the life of the NSK bearing will not be long. Therefore, if you want to install NSK bearings, you should know how to install NSK...

The reasons for the failure of FAG bearings are often multi-factors. All influencing factors in the design and manufacturing process are related to the failure of the bearing, which is not easy to judge by analysis. In general, it can be considered and analyzed from two aspects: use factors and internal factors. The use factor m...