Welcome to Eric Bearing Limited! Quality Bearings at an Honest Price.
eric-skf-bearing
eric-skf-bearing-wap

News

News

Home > News >
03
2021.Aug

Eight Factors For FAG Bearing Heating

There are many reasons that cause the FAG bearing temperature to be too high. ERIC BEARING LTD has sorted out several common problems for everyone. 1. Poor lubrication Lubrication has an important impact on the service life of the bearing and friction, wear, vibration, etc. Good lubrication is a necessary condition to ensure the...
02
2021.Aug

The Purpose And Direction Of Rolling Bearing Preload

First, what is bearing preloading? The pre-tightening of rolling bearings refers to the initial pressure and pre-deformation generated between the rolling body of the bearing and the inner and outer rings during the installation of the bearing, so as to keep the inner and outer rings of the bearing in the state of compaction and...
30
2021.Jul

Assembly Method Of Rolling Bearings

The assembly of rolling bearings should be determined according to the structure, size and mating nature of bearing components. General assembly methods of rolling bearings include hammer method, compression method, hot loading method and cold shrinking method, etc. 1, the preparation work before the assembly of rolling bearings...
29
2021.Jul

Common Problems And Faults Of Reducer Bearings

1. Why do bearings have thrust clearance and expansion clearance? A) Metal materials have the properties of thermal expansion and cold contraction. When the shaft is operated at different temperature conditions, the length and diameter of the shaft will also change. Therefore, in order to ensure the formation of pressure oil fil...
28
2021.Jul

Reducer Bearing Standard Installation?

The reducer is a kind of rotating equipment, and the bearing plays a very important role in the rotation of the equipment. Therefore, the installation and detection of the bearing are very important when the reducer is in use. In the process of use, some common problems of reducer bearings are also the problem of everyones relat...
27
2021.Jul

Relationship Between Bearing Fit And Load Type

1. Basis for choosing cooperation According to the load acting on the agents bearing relative to the rotation of the ferrule, there are three types of loads borne by the ferrule: partial load, cyclic load, and swing load. Generally, cyclic load (rotating load) and swing load adopt tight fit; except for special requirements in us...
26
2021.Jul

Why cylindrical roller bearings only bear radial loads?

Cylindrical roller bearings are generally only used to bear radial loads. Only single-row bearings with ribs on the inner and outer rings can bear smaller directional axial loads or larger gap axial loads. What is bearing load? Bearing load is the load received by the bearing during use, including lateral load and longitudinal l...
23
2021.Jul

Rolling Bearing Assembly Method

The assembly of rolling bearings should be determined according to the structure, size and mating nature of bearing components. General assembly methods of rolling bearings include hammer method, compression method, hot loading method and cold shrinking method, etc. 1, the preparation work before the assembly of rolling bearings...
22
2021.Jul

Analysis of Seal Structure of Deep Groove Ball Bearing

Deep groove ball bearings have a variety of sealing structures. According to the different sealing materials, they are mainly divided into two types: rubber sealing ring and dust cover (standard iron cover): according to different seals, they can be divided into contact sealing and non-contacting. seal. For sealed deep groove ba...
facebook
twitter
email
r-top