SKF bearings|FAG bearings|INA bearings|TIMKEN bearings|NSK bearings - Eric bearing supplier

The types of NSK Bearings are very widely used, mainly in machinery to support and reduce friction, so the accuracy and noise of NSK bearings are directly related to the use and life of the machinery. Therefore, we need to pay attention to some matters when buying NSK bearings. 1. Selection of NSK bearing model: The NSK bearing ...

Many mechanical failures are related to the rolling bearings in rotation. The quality of the bearings has a great impact on the working state of the machinery. Its defects can cause abnormal vibration and noise in the equipment, and even damage the equipment in severe cases. The correct condition monitoring and diagnosis of roll...

After the FAG bearing is installed in the host, if the radial runout of the main shaft is measured, it can be found that the measured value of each revolution has a certain change; when continuous measurement is performed, it can be found that after a certain number of revolutions, this change will be approximately Repeatedly. T...

Mainly observe whether the rivet head is offset, skewed, loose, lack of meat, or whether the double eyelid welding position is correct, and the riveting or welding quality of the frame is maintained. The welding point is too large or too small, and whether it is caused by weak welding or excessive welding The phenomenon of jammi...

1. SKF bearing temperature is too high: When the mechanism is running, the part where the bearing is installed is allowed to have a certain temperature. When touching the housing of the mechanism with your hands, it is normal to not feel hot, otherwise it indicates that the bearing temperature is too high. The reasons for the hi...

Generally, the space in which IKO bearings can be installed is limited. In most cases, the shaft diameter (or bearing inner diameter) is based on mechanical design or other design constraints. Therefore, the choice of IKO bearing type and size is based on the inner diameter of the IKO bearing. Therefore, the main dimension table...

1. Selection of shaft and bearing and tolerance of control room Press-in bearings INA bearings should be flexible without blocks in the direction of rotation. If the rotation is significantly inflexible, the size of the shaft is too large, and the tolerance drops. As the tolerance of the shaft is obviously sandy after turning it...

FAG bearing use factors mainly refer to whether the installation adjustment, use and maintenance, maintenance and repair meet the technical requirements. According to the technical requirements of bearing installation, use, maintenance, and maintenance, monitor and inspect the load, speed, working temperature, vibration, noise a...

1. The impact of vibration on KOYO imported bearings. In normal use, vibration is very sensitive to bearing damage, peeling, indentation, rust, cracks, wear, etc. will be reflected in the bearing vibration measurement. Therefore, by using a special bearing vibration measuring device (frequency analyzer, etc.), the magnitude of t...